- BrandFirestone Building Products
- Country of manufactureUnited States
- PurposeFor roofing
Assembly UltraPly Bonding Adhesive TPO-glue
Article number according to the Firestone catalog: W56TPO3005
1. Description
The UltraPly Bonding Adhesive construction adhesive represents the contact adhesive on the basis of solvent intended for gluing of membranes of UltraPly TPO of production Firestone to the coordinated heat-insulating materials and also to the wooden, metal, stone and other coordinated bases.
2. Preparation
Surfaces on which the UltraPly TPO Bonding Adhesive construction adhesive is applied have to be pure, smooth, dry, and also not have sharp edges, loose materials, traces of oils, lubricants or other pollution. The surface to which the membrane is pasted has to be cleared by means of a brush or pure rags. Glue should be mixed carefully before use and during it for the purpose of receiving uniform mix without deposit at the bottom and visible clots. Just before use, in case of long storage of glue at temperatures below 15 °C, it is necessary to give it the chance to get warm to room temperature.
3. Drawing
The Bonding Adhesive construction adhesive should be applied at the same time on the lower surface of a leaf and the basis to which it will be glued, for the purpose of providing approximately equal time of drying. The Bonding Adhesive construction adhesive should be applied evenly, avoiding formation of flows. Apply glue with the painting roller steady against influence of solvents, and roll it on the stuck together surfaces. When putting construction adhesive it is necessary to provide absolutely uniform covering of both stuck together surfaces. Putting the Bonding Adhesive construction adhesive in places of joints of cloths of a membrane should be made with extra care. For providing more uniform covering and optimization of an expense of the gluing structure of Bonding Adhesive it is possible to use the device for putting RoofTop SuperSpreader glue.
4. Consumption rate
Consumption rates depend on degree of smoothness of the basis and a way of drawing: at manual drawing: one gallon for the area from 5 to 7 sq.m (on two surfaces); when drawing by means of the device RoofTop SuperSpreader: one gallon for the area from 7 to 9 sq.m (on two surfaces) Surfaces of some heat-insulating materials are rougher and porous that leads to increase in an expense of the gluing structure in comparison with smooth nonporous bases. The bases from materials of the increased porosity (neoshkurenny forest products, foam-concrete blocks) can demand drawing two layers of Bonding Adhesive glue for ensuring sufficient adhesion. Quality of gluing of a roofing membrane to the basis is checked by testing on a small site. For check paste a small piece of a membrane of UltraPly on the porous basis.
5. Packing / Storage / Expiration date
Packing: Bucket of 18,9 l (5 gallons) Storage: To store in the sealed factory container at a temperature from 15 °C to 25 °C. Not to allow hit of a direct sunlight until readiness for use. Expiration date: 12 months on condition of storage according to the above instructions. At influence of the increased temperatures the expiration date is reduced.
6. Precautionary measures
See. A reference guide according to safety measures during the work with material. Material is flammable. Storage and use near an open flame and sources of ignition is not allowed. Not to smoke in a usage time. To use only in well aired places. To avoid long contact with skin. Not to pollute foreign materials. This material is intended only for promyshlen-an application leg. To store in the places inaccessible for children. Dilution of this material is not allowed.