Floors industrial bulk Thin film

The impenetrable nonskid pigmented floors are suitable for light wheel vehicles, partially impenetrable to influence of not especially aggressive oils and liquids.

Thicknesses. less than 300 microns.

Description of a cycle

Preparation of the basic base.

Drawing layer of adhesive primer (2).

The subsequent drawing the center of the pigmented two-component mix (3).

Following second finishing layer of the same mix, same pigmentation (3).

At will, the satined and/or nonskid finishing is available.

Decision 1: Standard cycle

1 Concrete (basis)

2 Pava 100 glue - two-component epoxide without solvent with the high moistening ability

3 Pavafloor H200/E - the pigmented two-component epoxy mix without solvent with good chemical firmness and a high exit

Decision 2: Water cycle

1 Concrete (basis)

2 Reform-A Pava - two-component epoxy mix in water solution with the high moistening ability

3 Pavafloor H200/W2-the pigmented two-component epoxy mix in a water emulsion without solvent with good chemical and mechanical stability

Decision 3: A cycle with low extent of yellowing

1 Concrete (basis)

2 Pava 100 glue - two-component epoxide without solvent with the high moistening ability

3 Ultrapol Color Pava - the two-component polyurethane glossy mix steady against light, with the minimum yellowing