Installation of a heat-insulated floor in Almaty

The Heat-insulated floor system is usually mounted on that square which is free from furniture, bathroom equipment and other objects. It is explained by a possibility of economy of the electric power. The system can be installed during repair work indoors. At the same time, put a layer of a firm not fusible heat insulator on a draft surface of a floor (it as "Penofol" or "Izofleks"), further over a layer keeps within a heating cable in the form of the zigzag line with a certain step.

Apply the assembly tape which is available in a delivery set to installation of a heating cable. Thermal sensors keep within a special corrugated tube near a temperature regulator. Then the layer of cement and sand mix keeps within. After solution hardening, on a surface any decorative floor covering (linoleum, a tile, a laminate) can be necessary. Specially left ends of cables are brought to a temperature regulator.

In case the room has the big square or at a floor the big pressure, then laying of cement and sand mix is put to be made on the reinforcing grid.

Installation warm a floor can be made also in case of wooden overlappings. Heating cables keep within on the metal gauze located over a floor the available logs. Then cables connect to a temperature regulator and the system is ready to use. However, at installation of system on wooden overlappings, it is necessary to apply a cable with lower thermolysis (no more than 10 W/m), and its installation is made not so densely (no more than 80 W / kv.m).

At this stage works on installation of the Heat-insulated floor system come to the end.