(View map)
- BrandKazstanex
- Country of manufactureBelarus
- Type of welding equipmentManual welding
Kromkorez of manual VM - 20
[It is intended for processing of an edge of steel sheets from 15 to 60 degrees. ]
The manual car for processing of an edge of BM - 16
Appointment
It is intended for processing of an edge of steel sheets before welding, allows to chamfer ranging from 15 - to 60 - degrees, and also to tortsevat an edge.
It is used both at the large enterprises, and on small in the conditions of mass and small - scale production.
Kromkorez is convenient and easy - to - work. Its weight does not exceed 20 - kg. In the course of work the unit keeps at the expense of a body weight, and the movement on the processed surface is carried out on rollers that allows to make processing of an end face even at insignificant effort in the direction of cutting. The handle of the car is executed in irregular shape for convenience of work both on sheets, and on pipes.
For reduction of vibration of the handle have a corrugated rubber covering. Drive of a kromkorez electric. Connection to a network is carried out by means of a power wire with a fork and grounding. The electronic monitoring system of tension in case of an emergency disconnects tension. Kromkorez is delivered in a state, ready for use. Only necessary operation — is a setup of the machine for the necessary width of a cut and adjustment of an angle of milling. As the cutting tool the double face mill containing 12 - symmetrically located hard - alloy plates is used. Processing of a surface is made by method of counter milling. Estimated wear of plates comes after 150 - m running counting on each party of a plate. Processing of all width of a cut for one pass is in most cases possible. Preliminary processing of a surface after cutting by a gas cutting torch is not required. Kromkorez perfectly proved in work at many enterprises of the CIS countries and around the world.
ADVANTAGES
mobility, ergonomics, ease of management.
quality receiving the processed surface.
possibility of a tortsevaniye and receiving a facet up to 20 wide - mm.
ability of processing of end faces of pipes with a diameter more than 160 - mm.
ease of management.
almost instant adjustment of working parameters – a corner and depth of a cut.
-
Technical characteristics: |
Power supply | 220 - 240 - AC/50/60 - 0 - Hz |
The drive – the engine | electric single - phase, induction with the working condenser – W — - 1,1 - KW, n – 2 - 820 - об / mines |
The consumed current | 12 - ((14 - AND) |
Safety lock | 2 - / / 250 - |
Extent of protection | 1P54 - |
The used tool | two milling heads with hard - alloy plates |
Processing speed | 1,5 - |
Maximum width of a cut | 20 - (((for a corner 450) |
Range of adjustment of a corner of a cut | from 150 - 600, and also tortsevaniye |
Lump, kg | 20,5 - |
Facet corner | 0 ° - 15 ° - 60 ° - |
Facet width | 20 mm |
Giving | Manual |
-
-