Mill laboratory LMTs - 1M
The mill laboratory LMTs - 1M is intended for grind of grain of wheat, rye and other cultures by humidity to 20% to the set fineness by preparation of tests for determination of quality of a gluten, "falling number" and other indicators of quality.
The mill laboratory can be used in laboratories of the hlebopriyemny, flour - grinding enterprises, in system of agriculture, the selection and research organizations.
The principle of work of a mill is based on giving to the processed material of centrifugal acceleration at which it, interacting with a rough (abrasive) surface, is crushed to the stable size of particles. The received meal, having passed a calibration sieve, comes to a cyclone from where air via the filter is taken away in the atmosphere, and meal is poured in a premny glass.
The mill laboratory is completed with calibration sets with openings with a diameter of 0,8, 0,9 and 1,0 mm. The mill consists of the case in which there is an electric motor. The engine shaft with the krylchatka fixed on it leaves in a razmolny chamber on which periphery the feedwell with a rough surface is located. The output window from a chamber through a calibration sieve and the channel is connected to a cyclone and the filter of purification of air. Under a cyclone on a mobile support the reception glass is installed. From above on the removable cover attached to the case by locks the loading bunker with the dosing plate and the valve of produvny cleaning is located. On the case of a razmolny chamber the limit switch which for safety is not allowing turning on of the engine at an open cover is installed.
Before work it is necessary to establish the required sieve and a reception glass for a razmolny product. In the loading bunker fill up a hinge plate of grain and install the toggle - switch in the situation "START - UP". Speed of supply of grain from the loading bunker is established on the gap regulated by the dosing plate. Upon termination of receipt of a product in a reception glass the razmolny chamber is cleared, having pressed several times the valve of produvny cleaning. Then the toggle - switch is put in position "is SWITCHED OFF" and after a full stop of the engine take out a glass with the crushed product.Technical characteristics.
|The mass of the ground product,||10 - 80|
|Time of grind of a hinge plate weighing 50 g, with||40 - 50|
|Frequency of rotation of working body, rpm||18 000|
|Volume of the loading bunker, cm3||60|
|Volume of a reception glass of a product of grind, cm3||200|
|Power consumption, W||800|
|Duration of continuous work, no more mines||10|