Plates polystyrene foam for thermal ceilings

We use plates from expanded polystyrene

Special insulating products from expanded polystyrene fasten directly to a wall by means of glue structure. Connection is made in a crest and the tongue.

Thanks to it leakage of warmth through joints decreases almost to zero. As expanded polystyrene possesses quite good moisture - proofness, creation of a steamproof layer needs to be done not always.

Indisputable advantage that the technology of warming of walls from within expanded polystyrene combines, simple installation is. However the method has some shortcomings.

If conceived to finish the warmed surface one way or another (for example, plaster or wall - paper), it is necessary to establish in addition the sheets made of a plaster cardboard.

How fastens penopolistirolovy plates?

Process of installation is carried out as follows - in the beginning glue solution is applied on a reverse side of products.

It becomes flat cakes. Then expanded polystyrene is pasted to a wall surface.

It is important to observe the shift of layers between the plates located in adjacent ranks. The basis has to be leveled, well dried up and cleared of different pollution (dust, oil and so forth).

If the surface is required to be trimmed with a ceramic tile, warming of walls includes installation of strips of fiber glass fabric. Establish the corresponding products on sites of joints to polystyrene foam plates. Similar strips connect among themselves with an overlap. Blousings on width - 10 cm.

From above glass cloth strips solution is put. Thickness - 2 mm. The tile turn comes. Other option of finishing - plaster, a pokleyka of wall - paper.

Previously it is necessary to cover walls as it was told above, a plaster cardboard. That's all, process of internal warming is complete. The room became much warmer.