It is used at diagnostics of diseases or injuries which influence structural properties of front department of an eye. The slit lamp of Xcel - 255 is ideally suited for carrying out polyclinic and stream diagnostics and work in salons of optics. The verified ergonomic design and high reliability do it by the irreplaceable tool of the ophthalmologist.
It is applied in ophthalmologic departments of medical institutions.
Technical characteristics: Device body: A microscope - Galilee;
Increase change - the Drum 3 positions; The Eyepiece - 12.5X;
Increase coefficient - 10X 16X 25X;
Range of interpupillary distances - 54 - 74 mm;
Adjustment of a diopter - + / - 5;
Slot - hole illumination - 6 volts 20 watts galogenovy;
Crack width - 0 - 13.5 mm;
Crack length - 1.5 - 12.5 mm;
Crack aperture (diameter of a lens of a microscope) - 0.6, 5.8, 9, 13.5 mm;
Rotation of a crack - 0o - 180o;
Filters: Redless, Thermal, Blue cobalt;
Range of movements: Longitudinal (of) - 90 mm, Cross (to the left/to the right) - 107 mm, Vertical (up/down) - 30 mm, Adjustment of height of a chin - 80 mm;
Tension - 90 - 250 volts, alternating current;
Frequency - 50 / 60 hertz; Input power - 35 W;
The table basis sizes - 465 mm x 316 m (18 1/2" x 12 10/16");
Weight (with packaging) - 52 pounds (23.64 kg).
Lever of focusing of 1 piece: insert the focusing lever on a rotary core of the device to make approximate correction of interpupillary distance and correction of sharpness. Arrange the lighter on a flat surface of the lever of focusing and adjust interpupillary distance and focus of an eyepiece so that it was convenient to the operator. Remove the focusing lever;
Hexagon key of 1 piece: fix a head restraint by means of screws under an internal hexagon and a hexagon key it (is applied). Connect a wire of grounding of the transformer to the screw of grounding of a head restraint and tighten the screw (twisting the moment to 7.8 Nanometers);
Antidust cap of 1 piece: it is applied.
Halogen lamp (main) 1 piece: insert a cable from the lamp handle into a connector on a reverse side of the transformer;
Covers of the directing bar of 2 pieces: it is applied;
Replaceable safety locks of 2 pieces: find the black holder of a safety lock on back part of the power supply unit. Remove a network cord, insert the small screw - driver from each party of the holder of a safety lock and accurately raise edges to open;
Packagings of paper for a support for a chin of 2 pieces - reserve papers are applied;
