Tape PIL Almaty

Adhesive tape PIL, PVH - L Tape (LENTA PVH - L)

the Tape polyvinylchloride sticky - the rolled material received in the valtsekalandrovy way on the basis of the plasticized polyvinylchloride with addition sacred and thermostabilizers with drawing on one party of a glue layer which at rewind of 1 roll does not exfoliate is intended for isolation of oil and gas pipelines and does not come over to other side of a tape. The tape is intended for protection against corrosion of an external surface of the main oil and gas pipelines at construction, repair, and also for a waterproofing of heat conductors. Recommendations about application: A temperature interval of operation of a tape from - 30 °C to + 30 °C. At air temperature below 10 °C it is necessary to sustain a tape not less than 48 hours at a temperature from 15 °C to 40 °C. The technical characteristic the Thickness Brand B Brand A, mm 0, 20±0, 05 0, 30±0, 05 0, 40±0, 05 Width, of mm 450±11 500±10 Tensile strength at stretching, MPa, not less than 17, 5 15 Relative lengthening at a gap, % , not less than 190 170 Temperature of fragility, "With, is not higher than - 30 - 30 Specific volume resistance at 20 °C, cm Ohm, on less than 1х1011 1х1011 Stickiness, with, not less, for thickness 0, 20mm 20 10> 0, 30 mm 25 15 Hygienic certificate No. 2. BTs. 01. 224. P. 00106. 02. 03 of February 12, 2003 Tape PVH - L is intended for a winding of the main oil and gas pipelines as isolating and a sheeting. It is used at installation and repair of pipelines. The tape has no openings, bubbles, cracks, admissions of a glue layer on all the area and anguishes on edges. The glue layer at rewind of a roll does not exfoliate and does not come over to other side of a tape. Roll surface smooth. The tape made of polyvinylchloride composition by a valtsekalandrovaniye with drawing a glue layer on the one hand.