The car for removal of a facet of VM-21

The car for removal of a facet of VM-21
[Speed of processing of 1,5 m/min, giving manual]

The car for removal of a facet of VM-21

Appointment

It is intended for processing of an edge of sheets and pipes from stainless steel, allows to chamfer ranging from 0 - to 60 - degrees, and also to tortsevat an edge.

It is used both at the large enterprises, and on small in the conditions of mass and small-scale production. Kromkorez is convenient and easy-to-work. Its weight does not exceed 20 - kg. In the course of work the unit keeps at the expense of a body weight, and the movement on the processed surface is carried out on rollers that allows to make processing of an end face even at insignificant effort in the direction of cutting. The handle of the car is executed in irregular shape for convenience of work both on sheets, and on pipes. For reduction of vibration of the handle have a corrugated rubber covering. The drive of a kromkorez electric with the raised starting current. Connection to a network is carried out by means of a power wire with a fork and grounding. The electronic monitoring system of tension in case of an emergency disconnects tension. Kromkorez is delivered in a state, ready for use. Only necessary operation — is a setup of the machine for the necessary width of a cut and adjustment of an angle of milling. As the cutting tool the unary face mill containing 10 - hard-alloy plates is used. Processing of a surface is made by method of counter milling. Estimated wear of plates comes after 150 - m running counting on each party of a plate. Processing of all width of a cut for one pass is in most cases possible. Preliminary processing of a surface after cutting by a gas cutting torch is not required. Kromkorez perfectly proved in work at many enterprises of the CIS countries and around the world.

 -

ADVANTAGES

New generation of portable faskosnimatel of BM-21 - for processing of an edge of a leaf and pipes before welding.

mobility, ergonomics, ease of management.

quality receiving the processed surface.

possibility of a tortsevaniye and receiving a facet up to 21 wide - mm.

ability of processing of end faces of pipes with a diameter more than 160 - mm.

ease of management.

almost instant adjustment of working parameters – a corner and depth of a cut.

expanded working range is from 0 - to 60 - degrees with smooth adjustment.

the new monoblock mill with ten hard-alloy plates, considerably improves working process

the fast and convenient replacement of plates which is not demanding the special tool and experience.

one universal guide replacing three different adaptations in BM-20.

 4 - a quencher of vibration, protecting the operator and the car from harmful vibration.

Technical characteristics:

Power supply	230VAC/50Hz or 115 - VAC/60 - Hz
The drive – the engine	the electric motor with the raised starting current – W — - 1,1 - KW, n – 1 - 410 -об / mines
The consumed current	12 - ((14 - AND)
Safety lock	2 - / / 250 -
Extent of protection	1P54 -
The used tool	Monoblock milling head with 10 - TCT plates
Processing speed	1,5 -
Maximum width of a cut	21 - (((for a corner 45 °-)
Range of adjustment of a corner of a cut	from 0 ° - 60 ° - and also a tortsevaniye
Lump, kg	19,9 -
Facet corner	0 ° - 60 ° -
Facet width	20 mm
Giving	Manual
Vibration suppression	Yes

 -