The MARK-602MP/1 conductometer saline tester (IP65)/stationary two-channel for the main measurements (the block preobr. with the sensor, a cable of compound 5m, RE)

The MARK - 602MP/1 conductometer saline tester (IP65)/stationary two - channel for the main measurements (the block preobr. with the sensor, a cable of compound 5m, RE)

It is applied on objects in fish breeding, in chemical, food, pharmaceutical industry.

The conductometer is an ordinary measuring device with two channels which is intended for measurement of UEP or salinity, equivalent on UEP, in terms of chloride sodium (NaCl) on two channels of measurement in the continuous mode. The measured parameters are displayed on the digital liquid crystal indicator. There is an opportunity to use the modes of indication of the measured parameters in channel A or in channel B and the modes of simultaneous indication of parameters of channels A and B. On channels the programmable subrange of measurement on a current exit is provided. The lower limit of programmable subrange of measurement on a current exit is always equal 0 mksm/cm (0 ^mg/dm3). It is possible to set an upper limit ranging from 0,1 mksm/cm (from 0,1 ^mg/dm3) to the upper bound of range of measurement determined by type of the connected sensor. The set upper limit of measurement on a current exit can be displayed on the indicator. The device has 2 exits with the output unified signals of a direct current from 0 to 5 ma or from 4 to 20 ma which correspond to two channels of measurement of specific electric conductivity or salinity. The upper limit of programmable subrange of measurement on a current exit corresponds to current 5 or 20 ma. The choice of necessary range of a current exit (from 0 to 5 ma or from 4 to 20 ma) is carried out separately for each channel through an option in the menu of the device. In the device there is an opportunity to establish for each of channels of the output unified signal from 0 to 20 ma.